My cuts are not straight. What can I do?

What usually works is to keep the tension gentle and break the tear into two sections:

Start with a light, controlled pull at roughly a 45° angle for about 70–80% of the length.
Pause briefly (maintaining gentle tension), then finish with a short, smooth upward motion.

This should help avoid the downward drop at the end, which is when most tears happen.

If you haven’t tried it yet, the serrated edge can give better control and if you keep having trouble, feel free to send us a short video of your setup.

We will be happy to check what is happening and guide you step by step.

Still need help

Can't find what you're looking for? Reach out and we'll sort it